Features of silicone rubber heating plate:

1. various shapes and sizes (such as round, oval, cone) can be customized.

2. The insulating layer of the silicone rubber heating plate is composed of silicone rubber and glass fiber cloth, which has high insulation performance, and the breakdown voltage can reach 20-50KV/mm, so it can be used with confidence.

3. The silicone rubber heating plate is extremely convenient to install. It can be installed through room temperature vulcanized rubber, vulcanized, or installed in holes according to customer requirements, or installed in the form of bundles.

4. Heating element: Winding the heating wire of nickel alloy on the glass fiber wire, the heating power can reach 2.1W/c㎡, and the heating is more uniform.

5. Moisture-proof and chemical-proof silicone rubber material provides longer heater life.

Technical parameters:

1) High temperature resistance of insulating material: 250℃

2) High operating temperature: 250℃-300℃

3) Insulation resistance: ≥5 MΩ

4) Compressive strength: 1500v/5s 5) Power deviation: ±8%

6) Withstand voltage: >5 KV,

7) For example, 20mm×60mm, thickness 1.5mm (thin 0.8mm, thickness 4mm) lead length: standard 200mm, can be customized.

Instructions for use:

1. When using this type of electric heater, it must be noted that its continuous working temperature should be less than 240℃, and the instantaneous temperature should not exceed 300℃.

2. The silicone electric heater can work and press, that is, use the auxiliary pressure plate to make it close to the heated surface. The heat conduction is good, and the current density can reach 3W/c㎡ when the temperature in the working area does not exceed 240℃.

3. The allowable working temperature is less than 150°C under the condition of stick-on installation.

4. In the case of dry burning in the air, due to the temperature resistance of the material, the power density should be less than 1 W/c㎡; in non-continuous working conditions, the power density can reach 1.4 W/c㎡.

5. The working voltage selection is based on the principle of high power-high voltage, low power-low voltage, and special needs can be listed.

Application:

1. The heating, mixing and heat preservation of industrial equipment pipes, tanks, towers, tanks in humid and non-explosive gas occasions can be directly wound on the surface of the heated part during use.

2. Refrigeration protection and auxiliary heating of air-conditioning compressors, motors, submersible pumps and other equipment,

3. Medical equipment such as blood analyzers, test tube heaters, medical and health care shapers, body shaping and slimming belts to compensate for heat, etc.