Size, power and voltage can be made according to your design.
.
Product description
The water-boiling type electric heating tubular element is a common industrial consumable component and is replaced frequently. Sinton brand tube heating tubular element products are positioned as electric heating elements with high cost performance and wide audience, with the hope that customers can complete the production process with less cost and create value for customers.
Features
The copper tube shell is soft and has good thermal conductivity. It is suitable for tap water heating with a lot of scale. The normal service life is more than three months under conservative estimates. For a few scenarios with high requirements, the service life may be shorter.
Support samples
If the electric heating tube you purchased before is easy to be damaged, you can buy a small amount of this model for trial, and if you are satisfied with the effect, you can cooperate for a long time.
Precautions before installation
New water immersion heaters are shipped after passing the inspection. As the heating tube is damaged in use, there will be a possibility of leakage. Therefore, the shell of the equipment must be grounded reliably, and a leakage protection switch must be installed.
.
The replacement and installation of electric water heating elements requires professional engineers to operate to avoid safety accidents caused by improper operation.
Although the heating tube has been tested before leaving the factory, it is recommended to use a multimeter to measure whether it is energized again before installation, and use an insulation shaker to measure whether there is leakage, and then install it if it is in good condition. In this way, if there is a problem after installation, the cause of the heating rod can be ruled out, and then the cause can be found from other aspects.
Is there electricity in the water after the power is turned on?
When the resistance heating element is in good condition, there is a slight current in the water, which does not exceed the safe value, but Sinton recommends that your body should not touch the water when the heating element is turned on.
If there's any copper flange immersion heater tubular element inquiry, welcome contact with us and we are professional with better services and high quality copper flange immersion heater tubular element.
Sinton Group mainly make kinds of electric heating elements and temperature sensor: For example , cartridge heater,hot runner coil heating element, tubular heater element, ceramic emitter, ceramic plate heating element, aluminium casting heater, mica band heater, ceramic band heating elements, Flexible ceramic heating pad, kapton heater, PI film heating elements, resistance wire, thermocouple, Pt100 etc. Also we make industrial heaters for example air duct heater, pipeline heater, oil circulation heater, drying oven etc. All of our heaters and temperature sensor can be OEM and now we have acquired CE certificate for our heating elements.
.
