Size: D40*35, they also can be made according to your design.
Surface load :Standard 4.5W/cm²
Sinton Copper injection band heater Power and Voltage: AC250V/250W, they also can be made according to your design.
Sinton copper Barrel band heating element Features：
1.With beautiful appearance, reasonable design and long service life, it can save the number of replacements, reduce downtime, and improve the production efficiency of the injection molding machine!
2. The German high temperature resistant mica board is used, which has the characteristics of high temperature resistance and good insulation performance.
3. The German Thermomaster high temperature heating wire has the advantages of fast heat dissipation, uniform heat dissipation, high pressure and high temperature resistance.
4. Fast heat conduction and long life, it makes the surface of the heating element beautiful, and has the advantages of uniform heat dissipation and high temperature resistance.
Technical data sheet:
1. Conditions of use: Ambient temperature: -20℃ ~ +60℃
2. Electric strength: It can pass the voltage 1500V/50HZ sinusoidal alternating current withstand voltage test, which lasted for 1MIN without breakdown.
3. Leakage current: <5MA
4. Insulation resistance in cold state: >50MΩ
5. Grounding resistance: <10Ω
6. Temperature resistance: the surface temperature of the machine can reach 500℃ without burning.
7. Power deviation: ±10%
Brass band heater datasheet
Product name | Brass Band Heater | Product thickness | 3mm-5mm |
Ambient temperature | -20-60℃ | Voltage | 9V-380V |
Insulation resistance | ＞50MΩ | Power | 50W-2000W |
Leakage current | ＜5MA | Size | Accept customization |
Application | Injection molding machines, extruders, etc. | Power deviation | ±10% |
Brass band heater datasheet
Product installation and use precautions:
1. The contact surface of the location where the electric heating element is installed should be flat and free of unevenness.
2.The electric ring heating element should be placed dry to avoid immersion in water to affect its insulation performance.
3.When installing the band resistance element, first check whether the installation position is consistent with the specifications of the electric heating element, and whether the voltage used is consistent.
4.After installation, check whether the hexapod bolts, wiring seat bolts and wiring bolts are locked, so as to avoid thermal expansion and cold contraction affecting the life of the product.
5. Injection molding machine band heating element should be used under the specified voltage. Considering that the voltage in some areas fluctuates greatly at night, the company recommends using a voltage stabilizer to avoid affecting the efficiency and life of the product.
Sinton Group mainly make kinds of electric heating elements and temperature sensor: For example , cartridge heater,hot runner coil heating element, tubular heater element, ceramic emitter, ceramic plate heating element, aluminium casting heater, mica band heater, ceramic band heating elements, Flexible ceramic heating pad, kapton heater, PI film heating elements, resistance wire, thermocouple, Pt100 etc. Also we make industrial heaters for example air duct heater, pipeline heater, oil circulation heater, drying oven etc. All of our heaters and temperature sensor can be OEM and now we have acquired CE certificate for our heating elements.
